Durango 2WD V8-5.2L VIN Y (1999)
INSTALLATION
NOTE: The ramped or open end of the coil spring is the bottom of the spring.
1. Tape the isolator pad to the top of the coil spring. Position the spring in the lower suspension arm pocket. Be sure that the coil spring is seated in
the pocket.
2. Install Spring Compressor DD-1278 up through the lower suspension arm, coil spring upper shock mounting hole.
3. Tighten the tool nut to compress the coil spring.
4. Install the lower ball joint into the knuckle and tighten the nut to 127 Nm (94 ft. lbs.). Install cotter pin.
5. Remove the spring compressor tool.
6. Install the stabilizer bar link to the lower suspension arm and tighten nut to 47 Nm (35 ft. lbs.).
7. Install the shock absorber.
8. Install the wheel and tire assembly.
9. Remove support and lower the vehicle.
