Durango 2WD V8-5.2L VIN Y (1999)
Windshield Washer Spray Nozzle: Service and Repair
REMOVAL AND INSTALLATION
Front
1. Remove the cowl plenum cover/grille panel from the cowl top. See Wiper Motor/Service and Repair for the procedures.
2. From the underside of the cowl plenum cover/ grille panel, disconnect the washer hose from the nozzle fitting.
3. From the underside of the cowl plenum cover/ grille panel, compress the retaining tabs of the washer nozzle and push the nozzle out through
the top of the panel.
4. Reverse the removal procedures to install.
Rear
1. Using a trim stick or another suitable wide flat-bladed tool, pry gently at each side of the rear washer nozzle to release the snap clips that
secure it to the liftgate outer panel.
2. Pull the nozzle out from the liftgate outer panel far enough to access and disconnect the washer supply hose from the nozzle nipple.
3. Reverse the removal procedures to install.