Durango 2WD V8-5.7L Hybrid (2009)
18. Connect the 12 Volt battery system ground isolation connector (1).
Without ESP
WITHOUT ESP
1. Install the spacer block and gaskets if removed.
2. Guide the booster studs into the cowl panel holes and seat the booster (1) on the panel.
3. Install and tighten new booster attaching nuts (2) to 28 Nm (250 in. lbs.).
4. Install the booster push rod (1) on brake pedal and install clip.
CAUTION: Do not reuse the original stop lamp switch. Anytime a switch has been removed or its position compromised, a new switch must be
installed and adjusted. Do not attempt to readjust the switch.
5. Install and adjust a NEW stop lamp switch. See: Lighting and Horns/Brake Light Switch/Service and Repair/Stop Lamp Switch - Installation.
