Durango 2WD V8-5.7L Hybrid (2009)
12. Remove the air filter housing assembly.See: Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and Repair/Air
Cleaner Body - Removal
13. Remove the upper radiator support bracket bolts (2) and the upper radiator support bracket (3).
14. Remove the upper radiator hose.
15. Remove the overflow tube.
16. Remove the radiator cooling fan. See: Radiator Cooling Fan
17. Remove the upper transmission oil cooler to radiator screws.
18. Remove the LH and RH radiator side seals.
19. Remove the radiator by lifting up.
Engine Cooling Radiator - Installation
5.7L HEV ENGINE
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
1. Position the radiator in the vehicle.
2. Position the isolator pins into the alignment holes in the radiator lower support
3. Install the upper transmission oil cooler to radiator screws.
4. Install the upper radiator support bracket (3). Tighten the bolts (2) to 10 Nm (89 in. lbs.)
5. Install the LH and RH radiator side seals.
6. Install the upper radiator hose.
