Durango 2WD V8-5.7L Hybrid (2009)
Harmonic Balancer - Crankshaft Pulley: Service and Repair
Vibration Damper - Installation
INSTALLATION
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
CAUTION: To prevent severe damage to the crankshaft, damper, and damper installer 8512A, thoroughly clean the damper bore and the
crankshaft nose before installing damper.
1. Position damper onto crankshaft.
2. Assemble Damper Installer 8512 (2) , and the Pressing Cup (1) from A/C Hub Installer 6871.
3. Using Damper Installer 8512, and the pressing cup from A/C Hub Installer 6871, press damper onto crankshaft.
4. Install then tighten crankshaft damper bolt to 176 Nm (130 ft. lbs.).
5. Install cooling fan.
6. Install radiator upper shroud and tighten fasteners to 11 Nm (95 in. lbs.).
7. Install radiator upper hose.
8. Install water pump drive belt (1) See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal and
Replacement/Serpentine Accessory Drive Belt - Installation.
9. Refill cooling system See: Cooling System/Service and Repair.
10. Power the vehicle up See: Starting and Charging/Battery/Testing and Inspection.
