Durango 2WD V8-5.7L Hybrid (2009)
CAUTION: Make sure that the retainers (1) and the rocker arms (2) are not overlapped when tightening bolts or engine damage could result.
CAUTION: Due to the changes in the pushrod clearance holes in the Eagle 5.7L cylinder heads, close attention must be given when installing
the pushrod(s) into the tappet(s). Once the pushrod(s) have been installed, use a suitable light to look down through the pushrod
hole(s). This will allow you to verify the pushrod(s) are centered properly in the tappet(s) and avoid engine damage. Recheck after
the rocker shaft assembly has been installed and tightened to specification.
CAUTION: The longer pushrods are for the exhaust side and the shorter pushrods are for the intake side.
NOTE: Pushrods must be installed in the same order as removed.
6. Install the rocker arm shaft and pushrods See: Rocker Arm Assembly/Service and Repair/Valve Rocker Arm - Installation
7. Using the sequence shown, tighten the rocker shaft bolts to 22 Nm (16 ft. lbs.).
