dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Procedures|Page 7033 > < Procedures|Page 7031
Page 19
background image

6. Connect the A/C suction line and A/C liquid line to the A/C expansion valve.
7. Install the nut (3) that secures the refrigerant line tapping block to the A/C expansion valve. Tighten the nut to 23 Nm (17 ft. lbs.).
8. On models equipped with the rear heating-A/C system, connect the underbody refrigerant line to the A/C suction lineSee: A/C Suction Line -

Installation  and See: Coupler HVAC/Service and Repair/Refrigerant Line Coupler - Installation.

9. Install the right front wheelhouse splash shield.

NOTE: 5.7L gas only engine shown. 5.7L HEV engine similar.

10. Lower the vehicle.
11. Remove the tape or plugs from the open suction line fittings.
12. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it and a new gasket onto the suction line fitting. Use only the specified

O-ring as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the
vehicle.

13. Connect the front section of the A/C suction line (4) to the rear section of the A/C suction line (2) and install the retaining nut (1). Tighten the nut

to 23 Nm (17 ft. lbs.).

14. Install the air cleaner housing and resonatorSee: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner

Housing/Service and Repair/Air Cleaner Body - Installation.

WARNING: Always follow vehicle service procedures to properly connect batteries on an HEV model. Serious or fatal injury may result from

improper service procedures.

15. On HEV models, reconnect the battery system using the service disconnect at the battery pack   See: Hybrid Drive Systems/Battery System,

Hybrid Drive/Service and Repair

16. On gasoline only models, reconnect the negative battery cable.
17. Evacuate the refrigerant system See: Service and Repair/Refrigerant System Evacuate.

CAUTION: On HEV models, a small quantity of refrigerant oil may have been lost from the A/C compressor when the A/C suction line was

disconnected. Always replace the lost oil with the same amount of fresh clean ND-11 POE refrigerant oil prior to recharging the
A/C system. Never use PAG oil in an HEV model or operate the A/C system with an incorrect amount of oil in the system. Failure
to follow this caution may result in serious damage to the HEV A/C system.

18. Adjust the refrigerant oil level See: Specifications/Capacity Specifications/Refrigerant Oil Capacity.
19. Charge the refrigerant system See: Service and Repair/Refrigerant System Charge.

Rear

INSTALLATION

CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system See: Specifications/Capacity

Specifications/Refrigerant Oil Capacity . Failure to properly adjust the refrigerant oil level will prevent the A/C system from
operating as designed and can cause serious A/C compressor damage.

CAUTION: Always use ND-11 Polyester (POE) oil from Mopar(R) in Hybrid Electric Vehicle (HEV) models. Never use Polyalkylene Glycol

(PAG) oil in an HEV model. See Refrigerant Oil for more information.

CAUTION: Polyalkylene Glycol (PAG) oil can contaminate the refrigerant system of a Hybrid Electric Vehicle (HEV) and lead to A/C system

damage and failure. If the refrigerant recovery/recycling and charging equipment was last used on a non-HEV model, flush the

Procedures|Page 7033 > < Procedures|Page 7031