Durango 2WD V8-5.7L Hybrid (2009)
Vanity Lamp: Service and Repair
Vanity Lamp - Installation
INSTALLATION
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: Vehicles equipped with optional vanity lamps have a mirror with a single lamp that is integral to each sun visor. Each lamp is
independently controlled by an integral switch that is automatically actuated by the mirror cover. The bulb types and service
procedures are identical for each of these lamps.
1. Using small needle-nose pliers, carefully grasp the vanity lamp bulb (2) and align the base of the bulb with the socket in the lamp housing of the
sun visor (1).
2. Push the bulb straight into the socket until the base is fully seated.
3. Insert one tab on the top or the bottom of the lens (2) into the appropriate slot at the top or bottom of the lamp housing.
4. Flex the lens far enough to engage the loose tab into its slot in the lamp housing.
5. Reconnect the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician trained in
proper HEV service safety procedures must also reinstall the high voltage service disconnect into the high voltage battery pack.
