Durango 2WD V8-5.7L Hybrid (2009)
Parking Assist Control Module: Service and Repair
Park Assist Module - Installation
INSTALLATION
1. Position the park assist module (5) to the left quarter inner panel, behind the power liftgate module (3) to the rear of the C-pillar (2) and above the
left rear wheel housing.
2. Secure the module to the left quarter inner panel using three plastic push-in fasteners (4).
3. Reconnect the two body wire harness connectors (1) to the module connector receptacles.
4. Reinstall the trim onto the left quarter inner panel. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage
Compartment Trim/Quarter Trim Panel - Installation.
5. Reconnect the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician trained in
proper HEV service safety procedures must also reinstall the high voltage service disconnect into the high voltage battery pack.
