Durango 2WD V8-5.7L Hybrid (2009)
3. Connect the TEHCM electrical connector (1) to the valve body (2).
4. Connect the TEHCM 2-way electrical jumper connector (1).
NOTE: Orientate the alignment tab inside the passage sleeve with the slot in the electrical connector of the control solenoid valve assembly.
Engage the sleeve straight into the case bore and connector. Do not rotate the sleeve at any time. Make sure the sleeve is fully seated
into the case. When the sleeve is properly installed, the distance from the case surface to the end of the sleeve should be 14-16 mm
(0.55-0.63 in.).
5. Lubricate the seals on the passage sleeve with DEXRON(R) VI and install the passage sleeve.
6. Push up on the passage sleeve locking tab (1).
