dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Electrical - MIL ON/DTC P0A2D Set|Page 4850 > < Electrical - MIL ON/DTC P0A2D Set|Page 4844
Page 1
background image

Wiring Harness: All Technical Service Bulletins
Electrical - MIL ON/DTC P0A2D Set

NUMBER: 21-008-09

GROUP: Transmission

DATE: November 10, 2009

WiTech, StarSCAN(R), StarMOBILE DESKTOP CLIENT -OR- StarMOBILE STANDALONE MODE MAY BE USED TO PERFORM THIS
OPERATION.

SUBJECT:
MIL Illumination Due to POA2D

OVERVIEW:
This bulletin involves inspecting a body harness connector at the transmission and replacing a harness within the transmission.

MODELS:

2009

(HB)

Duragno

2009

(HG)

Aspen

NOTE:

This bulletin applies to vehicles equipped with 5.7L HEV Engine (Sales code HEH)

SYMPTOM/CONDITION:

Customers may experience intermittent MIL Illumination. No other symptoms will be noted or experienced. Further investigation by the technician may
find DTC P0A2D - Drive Motor A Temperature Sensor 1 Circuit High.

DIAGNOSIS:
Using a Scan Tool with the appropriate Diagnostic Procedures available in TechCONNECT, verify all engine systems are functioning as designed. If
DTC's other than those listed above are present record them on the repair order and repair as necessary before proceeding further with this bulletin. If the
above symptom/condition is experienced, perform the Repair Procedure.

PARTS REQUIRED:

SPECIAL TOOLS / EQUIPMENT REQUIRED:

REPAIR PROCEDURE:

WARNING:

Be certain the procedure for the high voltage check-out has been performed and the service disconnect has been disconnected. Failure to follow these
instructions may result in serious or fatal injury.

1. Perform High Voltage Power Down Procedure. Refer to DealerCONNECT > TechCONNECT > Service Info > 08 - Electrical > 8F - Engine

Systems > Battery System > Standard Procedure > High Voltage Power Down.

Electrical - MIL ON/DTC P0A2D Set|Page 4850 > < Electrical - MIL ON/DTC P0A2D Set|Page 4844