Durango 2WD V8-5.7L VIN 2 (2007)
Parking Assist Control Module: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the trim from the left quarter inner panel to access the park assist module (5), which is located behind the power liftgate module (3) to the
rear of the C-pillar (2) and above the left rear wheel housing.
3. Disconnect the two body wire harness connectors (1) from the park assist module connector receptacles.
4. Remove the three plastic push-in fasteners (4) that secure the module to the left quarter inner panel.
5. Remove the module from the left quarter inner panel.
