Durango 2WD V8-5.9L VIN Z LDC (2000)
4. Do not unbolt fan blade assembly from viscous fan drive at this time.
5. Remove upper fan shroud attaching hardware.
6. Remove upper fan shroud and fan blade/viscous fan drive from vehicle.
7. After removing fan blade/viscous fan drive assembly, do not place viscous fan drive in horizontal position. If stored horizontally, silicone fluid in
the viscous fan drive could drain into its bearing assembly and contaminate lubricant.
8. Remove four bolts securing fan blade assembly to viscous fan drive.
INSTALLATION
1. Install fan blade assembly to viscous fan drive. Tighten bolts to 23 Nm (17 ft. lbs.) torque.
2. Position fan blade/viscous fan drive assembly and upper shroud into vehicle.
3. Install fan shroud retaining screws.
4. Install fan blade/viscous fan drive assembly to water pump shaft.
5. Connect battery negative cable.
