Durango 2WD V8-5.9L VIN Z LDC (2000)
Power Door Lock Relay: Service and Repair
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS AND SEAT BELTS/AIRBAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND
POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Remove the steering column opening cover and knee blocker from the instrument panel.
Relay And Fuse Block
3. Reach through the outboard side of the steering column opening in the instrument panel to access the relay and fuse block on the back of the
junction block.
4. Unplug the driver unlock relay from the relay and fuse block.
5. Install the driver unlock relay by aligning the relay terminals with the cavities in the relay and fuse block and pushing the relay firmly into place.
6. Connect the battery negative cable.
7. Test the relay operation.
8. Reverse the remaining removal procedures to complete the installation.
