Durango 4WD V8-4.7L Flex Fuel (2008)
INSTALLATION
SEAT CUSHION ELEMENT
CAUTION: During the installation of the replacement heating element, be careful not to fold or crease the element assembly. Folds or creases
will cause premature failure.
1. Peel off the adhesive backing on the back of the replacement heating element (2) and stick directly on top of the factory installed heating element
(1).
2. Connect the heated second row seat cushion element electrical connector (2) and install the harness routing clip to the rear center floor console
bracket (1).
3. Install the rear center floor console, See: Interior Moulding / Trim/Console/Service and Repair.
4. Connect the battery negative cable.
5. Verify heated rear seat system operation.
6. Install the appropriate seat cushion cover, See: Seat Cushion/Service and Repair/Seat Cushion / Cover - Installation.
NOTE: Make certain the seat wire harness is correctly routed through the seat and seat back. The excess wire between the cushion and
back elements should be securely tucked between the rear of the cushion foam and the rear carpet flap of the trim cover.
SEAT BACK ELEMENT