Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
NOTE: When programming a garage door opener or gate operator, it is advised to unplug the device or move the vehicle out of range during the
"cycling" process to prevent possible overheating.
-
3. Continue to press and hold the HomeLink(R) transceiver button while you press and release every two seconds ("cycle") your hand-held
transmitter until the frequency signal has successfully been accepted. The EVIC will display "CHANNEL X TRAINING" and then "CHANNEL X
TRAINED". Proceed with "Programming" step 4 to complete.
Erasing Homelink(R) Transceiver Codes
ERASING HOMELINK(R) TRANSCEIVER CODES
NOTE: Individual channels cannot be erased. Erasing the HomeLink(R) transceiver codes will erase ALL programmed codes.
To erase programming from all three buttons (individual buttons cannot be erased but can be "reprogrammed"), follow the step noted:
-
Press and hold the two outer HomeLink(R) transceiver buttons until the Electronic Vehicle Information Center (EVIC) displays "CLEARING
CHANNELS", do not release the buttons until "CHANNELS CLEARED" is displayed on the EVIC (after approximately 20 seconds). Release
both buttons. Do not hold for longer that 30 seconds. HomeLink(R) is now in the train (or learning) mode and can be programmed at any time
beginning with "Programming".
