Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
3. Connect the wire harness connector (2) to drive unit assembly (3).
4. Install the link rod assembly (6) onto the drive unit attachment point.
5. Install the left rear D-pillar (1) trim panel on the vehicle.
6. Install the link rod assembly (6) onto the liftgate attachment point (7).
7. Connect the battery negative cable.
8. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
9. Perform the power liftgate learn cycle.
10. Verify power liftgate system operation.