Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Oil Pan: Service and Repair
Installation
Installation - 4X2
INSTALLATION - 4X2
1. Clean the oil pan gasket mating surface of the bedplate and oil pan.
2. Position the oil pan gasket and pickup tube with new o-ring. Install the mounting bolt and nuts. Tighten bolt and nuts to 28 Nm (20 ft. lbs.).
3. Position the oil pan and install the mounting bolts. Tighten the mounting bolts to 15 Nm (11 ft. lbs.) in the sequence shown.
4. Raise the engine and remove the blocks of wood.
5. Lower engine and install both the left and right side engine mount through bolts. Tighten the nuts to 68 Nm (50 ft. lbs.).
6. Remove jack and install oil filter.
7. Install structural dust cover.
8. Install exhaust pipe onto exhaust manifolds.
9. Lower vehicle.
10. Install intake manifold.
11. Install throttle body resonator and air inlet hose.
12. Install upper fan shroud.
13. Fill cooling system.
14. Fill engine oil.
15. Start engine and check for leaks.
Installation - 4X4
INSTALLATION - 4X4
