Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
1. Position the rear mode door actuator (1) onto the side of the rear HVAC housing (2). If necessary, rotate the actuator slightly to align the splines
on the actuator output shaft (3) with those in the actuator coupler (4).
2. Install the screws (4) that secure the rear mode door actuator (2) to the rear HVAC housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the rear HVAC wire harness connector (1) to the rear mode door actuator.
4. Reconnect the negative battery cable.
5. Initiate the Actuator Calibration function using a scan tool.