Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Blower Motor Relay: Service and Repair
Controls - Front
Removal
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Locate the power distribution center (PDC) (1).
3. Open the PDC cover (2).
NOTE: Refer to the fuse and relay layout map on the inner surface of the PDC cover for rear blower motor relay identification and location.
4. Remove the rear blower motor relay (3) from the PDC.
Installation
INSTALLATION
NOTE: Refer to the fuse and relay layout map on the inner surface of the PDC cover for rear blower motor relay identification and location.
1. Position the rear blower motor relay (3) into the proper receptacle of the PDC (1).
2. Align the rear blower motor relay terminals with the terminal cavities in the PDC receptacle and push down firmly on the relay until the terminals
are fully seated.
3. Close the PDC cover (2).
