Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
9. Install the rear heater core retaining bracket (4).
10. Install the screw (3) that secures the rear heater core retaining bracket to the rear HVAC housing. Tighten the screw to 2 Nm (17 in. lbs.).
11. Connect the condensate drain tube (1) to the rear HVAC housing.
12. Install the outer half of the rear heater core and evaporator extension line flange (3).
13. Install the screws (2) that secure the two halves of the rear heater core and evaporator extension line flange together. Tighten the screws to 2 Nm
(17 in. lbs.).
14. Install the foam seal (1) to the rear heater core and evaporator extension line flange.
15. Install the blend door actuator (2) and the mode door actuator (3) to the rear HVAC housing (4).
16. Connect the rear HVAC wire harness (1) to the rear blend door actuator and mode door actuator.
