Durango 4WD V8-5.9L VIN Z (1998)
Carpet: Service and Repair
Front Carpet
FRONT CARPET
REMOVAL
1. Remove floor console.
2. Remove front seats.
3. Remove 2nd row seats.
4. Remove 3rd row seats, if equipped.
5. Remove front and rear door sill trim.
6. Remove lower left and right cowl trim.
7. Remove left and right B-pillar trim. Refer to Trim Panel.
8. Remove left and right quarter panel trim.
9. Loosen gas pedal bracket.
10. Remove rear fresh air vent.
11. Route wiring through carpet.
Fig. 3
12. Remove carpet from vehicle (Fig. 3).
INSTALLATION
1. Position carpet in vehicle and align all holes.
2. Route all wire harnesses through openings in carpet.
3. Install front and rear door sill trim.
4. Install quarter panel trim.
5. Install B-pillar trim. Refer to Trim Panel.
6. Install lower cowl trim.
7. Tighten gas pedal bracket.
8. Install 3rd row seats, if equipped.
9. Install 2nd row seats.
10. Install rear fresh air vent.
11. Install front seats.
12. Install floor console.
