Durango 4WD V8-5.9L VIN Z (1998)
Trim Panel: Removal and Replacement
A-Pillar Trim
A-PILLAR TRIM
REMOVAL
1. Remove A-pillar grab handle, if equipped.
2. Remove screws from cowl trim cover.
3. Remove cowl trim cover.
Fig. 1
4. Grasp A-pillar trim and pull outward to disengage clips attaching A-pillar trim to A-pillar (Fig. 1).
5. Separate A-pillar trim from vehicle.
INSTALLATION
1. Position A-pillar trim at A-pillar, align clips and press into place.
2. Install cowl trim cover.
3. Install A-pillar grab handle, if equipped.
A-Pillar Grab Handle
A-PILLAR GRAB HANDLE
REMOVAL
1. Using a small flat blade screw driver, pry trim plugs from A-pillar grab handle.
2. Remove screws attaching grab handle to A-pillar.
3. Separate A-pillar grab handle from vehicle.
INSTALLATION
1. Position grab handle on A-pillar.
2. Install screws attaching grab handle to A-pillar.
3. Install trim plugs in A-pillar grab handle.