Durango 4WD V8-5.9L VIN Z (1998)
3.
Remove the anchor bolt attaching the belt to the seat track (Figure 1).
4.
Remove the seat.
5.
Remove the screw that secures the recliner lever to the seat and separate the lever from the seat.
6.
Remove the two screws that secure the side shield to the seat cushion frame.
7.
Pull the seat cushion side shield away from the seat far enough to access the power seat switch module.
8.
Remove the two screws that secure the power seat switch to the inside of the seat cushion side shield (Figure 2) and separate the switch from the
side shield.
9.
Disengage the rearward corner J-straps.
10.
Disengage both side J-straps.
11.
Disengage the front J-strap.
12.
Disengage the hook and loop fastener.
13.
Separate the cushion and cover from the seat frame.
NOTE:
MAKE SURE THE PLASTIC ANTI-SQUEAK MAT IS PROPERLY INSTALLED PRIOR TO INSTALLING THE NEW CUSHION AND
COVER.
14.
Position the new cushion and cover (see Parts Required section) onto the frame.
15.
Engage the front J-strap.
16.
Engage both side J-straps.
