Durango 4WD V8-5.9L VIN Z (1998)
Brake Pedal Assy: Service and Repair
REMOVAL
1. Remove stop lamp switch.
Brake Pedal Mounting
2. Remove clip securing booster push rod to brake pedal.
3. Remove pedal pivot pin C-clip and slide pin out of support bracket and pedal.
4. Remove pedal and bushings.
INSTALLATION
1. Replace bushings if worn or damaged.
2. Lubricate pedal bushings and pivot pin with Mopar multi mileage grease, Lubriplate, or a silicone grease.
3. Install bushings in pedal and position pedal in support.
4. Insert pivot pin through support and pedal bushings and install C-clip.
5. Install booster push rod on brake pedal and install push rod retainer clip.
6. Install stop lamp switch.
