Durango 4WD V8-5.9L VIN Z (1998)
6.
Remove the caliper slide pins.
7.
Remove caliper from caliper adapter.
CAUTION:
DO NOT ALLOW THE CALIPER TO HANG BY THE BRAKE HOSE. USE A HANGER TO SUPPORT THE CALIPER WHILE SERVICING
THE BRAKE SHOES.
8.
Remove the outboard brake shoe (Figure 1). Pry one end of the shoe retainer spring away from the caliper, then tilt the shoe upward and rotate it
out of the caliper.
9.
Remove the inboard brake shoe by tilting the shoe outward until the retainer spring is clear of the caliper piston (Figure 2).
10.
Inspect the caliper adapter for wear in the location where the brake shoes rest on the adapter (Figure 3). If the wear is greater than 1.5 mm (0.060
in.) from the original surface, replace the steering knuckle (see Pans Required section). Refer to the 1999 Durango Service Manual (Publication
