Durango 4WD V8-5.9L VIN Z (1998)
Brake Pad: Service and Repair
REMOVAL
1. Clean master cylinder reservoir and filler caps.
2. Remove reservoir filler cap and drain approximately 1/4 of fluid from reservoir. Use clean suction gun or similar device to drain fluid.
3. Raise and support vehicle.
4. Remove front wheel and tire assemblies.
5. Bottom caliper pistons in bores with large C-clamp. Position clamp frame on rear of caliper and clamp screw on outboard brake shoe.
6. Remove caliper slide pins.
Removing Caliper Assembly
7. Remove caliper and brake shoes.
Outboard Brake Shoe
8. Remove outboard brake shoe. Pry one end of shoe retainer spring away from caliper. Then tilt shoe upward and rotate it out of caliper.
Inboard Brake Shoe