Durango 4WD V8-5.9L VIN Z (1998)
15.
Ensure the outboard brake shoe retainer springs are seated in the caliper (Figure 6).
16.
Install caliper and brake shoe assembly over the rotor and into the adapter. Be sure the brake shoe tangs are properly seated on the adapter ledges.
17.
Install and tighten the caliper slide pins to 25-35 N.m (18-26 ft. lbs.).
NOTE:
START THE SLIDE PINS BY HAND BEFORE TIGHTENING. DO NOT CROSS THREAD THE PINS.
18.
Perform Steps 5 through 17 to the front brakes on the other side of the vehicle.
19.
Install the wheel and tire assembly.
20.
Remove supports and lower the vehicle.
21.
Pump the brake pedal several times to seat the new brake shoes.
CAUTION:
VERIFY A FIRM BRAKE PEDAL BEFORE MOVING THE VEHICLE.
22.
Ensure that the master cylinder reservoir is at the proper level as indicated on the side of the reservoir. Fill the reservoir with Mopar Brake Fluid
p/n 04318080.
23.
Repeat the Diagnosis to ensure that the brake growl/grind noise has been eliminated.
