Durango 4WD V8-5.9L VIN Z (1998)
Brake Caliper: Service and Repair
Disassembly and Assembly
DISASSEMBLY
1. Drain old brake fluid out of caliper into drain pan.
Piston Dust Boot
2. Remove piston dust boot. Use screw
Caliper Piston Removal
3. Pad outboard shoe side of caliper interior with a minimum 1 inch thickness of shop towels. Towels will prevent piston damage when piston comes
out of the Caliper bore.
4. Remove caliper piston with short bursts of compressed air. Apply air pressure through fluid inlet port of caliper.
CAUTION: Do not blow the piston out of the bore with sustained air pressure. This could result in a cracked piston. Use only enough air
pressure to ease the piston out.
WARNING: Never attempt to catch the piston as it leaves the bore. This may result in personal injury.