Durango 4WD V8-5.9L VIN Z (1998)
Parking Brake Cable: Service and Repair
Front Cable Replacement
REMOVAL
1. Raise and support the vehicle.
Cable Tensioner
2. Remove cable adjuster nut.
3. Pull cable through the body mount.
4. Remove support and lower vehicle.
5. Remove left kick panel.
6. Fold left front edge of floor covering rearward and remove cable grommet from floor pan.
7. Engage parking brake pedal and remove cable from park brake pedal assembly.
8. Pull the cable through the floor pan.
9. Remove cable from vehicle.
INSTALLATION
1. Insert front cable through floor pan and install grommet.
2. Insert cable retainer into hole at bottom of pedal assembly bracket and connect cable end.
3. Install kick panel.
4. Raise and support vehicle.
5. Insert the cable through the body mount.
6. Install the cable into the tensioner and install the adjuster nut finger tight.
7. Perform parking brake adjustment procedure.
8. Remove support and lower vehicle.