Durango 4WD V8-5.9L VIN Z (1998)
Vacuum Brake Booster: Service and Repair
REMOVAL
1. Remove master cylinder.
2. Disconnect vacuum lines at booster.
Booster Rod Clip
3. Remove clip securing booster push rod to brake pedal.
Power Brake Booster Mounting
4. Remove nuts from booster mounting studs.
5. Remove booster and gasket from front cowl panel.
INSTALLATION
1. Position gasket on booster studs.
2. Guide booster studs into cowl panel holes and seat booster on panel.
3. Install and tighten booster attaching nuts to 28 Nm (250 inch lbs.).
4. Install booster push rod on brake pedal and install clip.
5. Install booster check valve if removed and connect vacuum hose to check valve.
6. Install master cylinder.
7. Fill and bleed brake system.
