Durango 4WD V8-5.9L VIN Z (1998)
Fan Blade: Service and Repair
The fan blades cannot be repaired. If fan is damaged, it must be replaced. Inspect fan as follows:
1. Remove fan blade and viscous fan drive as an assembly from the engine.
2. Remove fan blade assembly from viscous fan drive unit (four bolts).
3. Lay fan on a flat surface with leading edge facing down. With tip of blade touching flat surface, replace fan if clearance between opposite blade
and surface is greater than 2.0 mm (0.090 inch). Rocking motion of opposite blades should not exceed 2.0 mm (0.090 inch). Test all blades in this
manner.
WARNING: Do not attempt to bend or straighten fan blades if fan is not within specifications.
4. Inspect fan assembly for cracks, bends, loose rivets or broken welds. Replace fan if any damage is found.
CAUTION: If fan blade assembly is replaced because of mechanical damage, water pump and viscous fan drive should also be inspected. These
components could have been damaged due to excessive vibration.