Durango 4WD V8-5.9L VIN Z (1998)
Valve Cover: Service and Repair
Cylinder Head Cover Gasket
A steel backed silicon gasket is used with the cylinder head cover. This gasket can be used again.
REMOVAL
1. Disconnect the negative cable from the battery.
2. Disconnect closed ventilation system and evaporation control system from cylinder head cover.
3. Remove cylinder head cover and gasket. The gasket may be used again.
INSTALLATION
1. Clean cylinder head cover gasket surface.
2. Clean head rail, if necessary.
3. Inspect cover for distortion and straighten, if necessary.
4. Check the gasket for use in head cover installation. If damaged, use a new gasket.
5. Position the cylinder head cover onto the gasket. Tighten the bolts to 11 Nm (95 inch lbs.) torque.
6. Install closed crankcase ventilation system and evaporation control system.
7. Connect the negative cable to the battery.