Durango 4WD V8-5.9L VIN Z (1998)
H.
Route the distributor end of the coil wire down and behind the intake manifold, in front of the oil pressure switch (Figure 2).
NOTE:
THE COIL WIRE MUST BE A MINIMUM OF ONE (1) INCH AWAY FROM ANY OTHER IGNITION WIRES. THIS MAY REQUIRE THAT
THE COIL WIRE BE ROUTED UNDER VACUUM AND/OR WIRE HARNESSES IN THE RIGHT REAR CORNER OF THE INTAKE
MANIFOLD.
I.
Route the distributor end of the coil wire up the side of the distributor cap and onto the coil wire tower terminal.
J.
Position the original piece of coil wire convolute so it protects the wire against chafing with components at the rear of the engine.
2.
No.8 Cylinder Plug Wire Routing (Figure 3)
A.
Remove the No.8 cylinder plug wire from the distributor cap tower terminal.
B.
Remove the No.8 cylinder plug wire from the five-wire clip located at the lower rear of the valve cover.
C.
Route the No.8 cylinder plug wire over the rear quarter of the right valve cover (Figure 3).
D.
Position the original piece convolute from the No.8 cylinder plug wire to prevent chafing at the right valve cover and with other engine
components.
E.
Secure the No.8 cylinder plug wire and its convolute in place with the hose to wire clip p/n 06503441. The small end of the clip is
positioned over the convolute. The large end of the clip is fastened to a heater hose (A/C line on ZJ models).
NOTE:
MAKE SURE THE NO.8 CYLINDER PLUG WIRE IS SECURE AND AWAY FROM THE COIL WIRE AND THE NO.4 CYLINDER PLUG
WIRE. MAKE CERTAIN IT WILL NOT FALL DOWN AND CONTACT THE CYLINDER HEAD AND/OR EXHAUST COMPONENTS.
F.
Install the No.8 cylinder plug wire to its distributor cap terminal.
