Durango 4WD V8-5.9L VIN Z (1998)
Rear Seat Floor Duct Control - Split Bench Seat
1. Remove the three retainers that secure the HVAC rear bezel to the brackets near the back of the front seat center section.
2. Pull the bezel away from the back of the front seat far enough to access and disengage the control cable retainer and cable end from the
control.
3. Reverse the removal procedures to install.
Bucket Seat
The rear floor duct control and linkage are only serviced as a unit with the console duct assembly
Rear Seat Floor Duct Control - Bucket Seat
1. Remove the four screws that secure the console bin and remove the bin from the floor console.
2. Reach through the top of the console to disengage the control rod end from the floor duct damper door pivot.
3. Remove the floor console from the vehicle and disassemble as required to remove the console duct and control assembly from the console as a
unit.
4. Reverse the removal procedures to install.
Rear Seat Floor Duct
