Durango 4WD V8-5.9L VIN Z (1998)
Heater-A/C Housing Plenum Adapter Remove/Install
2. Slide the heater-A/C housing plenum adapter all the way to one side of the plenum opening.
3. Pull downwards sharply and firmly on the opposite side of the plenum adapter to disengage the snap feature from the plenum opening.
4. Remove the plenum adapter from the plenum panel.
5. When reinstalling the heater-A/C housing plenum adapter to the plenum panel opening, be certain that the snap features on each side of the adapter
are fully engaged with the sides of the plenum panel opening. This must be a water tight connection to prevent leaks.
6. Reverse the remaining removal procedures to complete the installation.
Rear Overhead A/C Outlet Bezel
The rear overhead A/C outlet bezel is used only on models with the optional rear overhead A/C unit. The outlet barrels located in the bezel are only
serviced as a unit with the rear overhead A/C outlet bezel.
Rear Overhead A/C Outlet Bezel Remove/Install
1. Using a trim stick or another suitable wide flat-bladed tool, gently pry between both ends of the rear overhead A/C outlet bezel and the headliner
to release the two snap clip retainers that secure the bezel to the rear overhead A/C unit housing.
2. Remove the rear overhead A/C outlet bezel from the headliner mounting hole.
3. Reverse the removal procedures to install.
