Durango 4WD V8-5.9L VIN Z (1998)
26.
Remove the two screws on the left and one screw on the right that secure the instrument panel center support bracket to the Airbag Control Module
(ACM) bracket on the floor panel transmission tunnel (Figure 9).
27.
Remove the center support bracket from the instrument panel.
28.
Disconnect the vacuum harness connector located near the left end of the heater-A/C housing
29.
Remove the screw that secures the instrument panel wire harness ground eyelets to the left side of the Airbag Control Module (ACM) mount on
the floor panel transmission tunnel.
30.
Disconnect the instrument panel wire harness connector from the ACM connector receptacle.
31.
Open the glove box.
32.
Locate the three screws in the bottom of the glove box bin. Remove only the center screw.
33.
Depress the two sides of the glove box bin far enough so that the rubber stop bumpers located on each side of the bin will clear the metal stops
located on the bracket on each side of the glove box opening.
34.
While holding the sides of the glove box bin depressed, roll the glove box downward until the stop bumpers are beyond the stops, then release the
sides of the bin.
35.
Grasp the upper outboard corner of the glove box door securely with both hands.
