Durango 4WD V8-5.9L VIN Z (1998)
Hazard Warning Flasher: Description and Operation
SYSTEM OPERATION
The combination flasher is a smart relay that functions as both the turn signal system and hazard warning system flasher. The combination flasher
contains active electronic Integrated Circuitry (IC) elements. This flasher is designed to handle the current flow requirements of the
factory-installed lighting. If supplemental lighting is added to the turn signal lamp circuits, such as when towing a trailer with lights, the
combination flasher will automatically try to compensate to keep the flash rate the same.
While the combination flasher has a International Standards Organization (ISO)-type relay terminal configuration or footprint, the internal
circuitry is much different. The combination flasher does not use standard ISO-relay inputs or provide ISO-relay type outputs or functions. The
combination flasher should never be substituted for an ISO-relay or replaced with an ISO-relay, or else component and vehicle damage may occur.
The combination flasher has five blade-type terminals intended for the following inputs and outputs: Battery B+, Ignition B+, Ground, Turn Signal
circuit, and Hazard Warning circuit. Constant battery voltage and ground are supplied to the flasher so that it can perform the hazard warning
function, and ignition switched battery voltage is supplied for the turn signal function.
Combination Flasher - Typical
The IC within the combination flasher contains the logic that controls the flasher operation and the flash rate. Pin 6 of the IC receives a sense
voltage from the hazard warning portion of the multi-function switch. When the hazard switch is turned on, the "hazard on sense" voltage will
become low due to the circuit being grounded through the turn signal bulbs. This low voltage sense signals the IC to energize the flash control
Positive-Negative-Positive (PNP) transistor at a pre-calibrated flash rate or frequency. Each time the PNP transistor energizes the hazard warning
circuit, the pin 6 "hazard on sense" voltage will become high and the IC signals the PNP transistor to de-energize the circuit. This cycling will
continue until the hazard warning switch is turned off.
Likewise, pin 8 of the IC receives a sense voltage from the turn signal portion of the multi-function switch. When the left or right turn signal is
turned on, the "turn signal on sense" voltage will become low due to the circuit being grounded through the turn signal bulbs. This low voltage
sense signals the IC to energize the flash control PNP transistor at a precalibrated flash rate or frequency Each time the PNP transistor energizes
the turn signal circuit, the pin 8 "turn signal on sense" voltage will become high and the IC signals the PNP transistor to de-energize the circuit.
This cycling will continue until the right or left turn signal is turned off.
A special design feature of the combination flasher allows it to "sense" that a turn signal circuit or bulb is not operating, and provide the driver an
indication of the condition by flashing the remaining bulbs in the affected circuit at a higher rate (120 flashes-per-minute or higher). Conventional
flashers either continue flashing at their typical rate (heavy-duty type), or discontinue flashing the affected circuit entirely (standard-duty type).
During turn signal operation, the combination flasher IC compares normal battery voltage input on pin 2 with the shunt resistor voltage input on
pin 7. If the IC "senses" that the voltage difference between pin 2 and pin 7 is different than the pre-calibrated value of the IC, it will increase the
rate at which it signals the PNP transistor to energize the pin 1 output. Thus, the inoperative half (left or right side) of the turn signal circuit will
flash faster.
Because of the active electronic elements within the combination flasher, it cannot be tested with conventional automotive electrical test
equipment. If the combination flasher is believed to be faulty, test the turn signal and hazard warning system circuits as described. Then replace
the combination flasher with a known good unit to confirm system operation.
The combination flasher cannot be repaired and, if faulty or damaged, it must be replaced.
