Durango 4WD V8-5.9L VIN Z (1998)
Controller Mounting Screws
4. Remove screws attaching CAB to the Hydraulic Control Unit (HCU).
5. Remove the CAB.
INSTALLATION
1. Place the CAB onto the HCU.
NOTE: Insure the CAB seal is in position before installation.
2. Install the mounting screws and tighten to 4 - 4.7 Nm (36 - 42 inch lbs.).
3. Connect the pump motor harness.
4. Connect the harnesses to the CAB and lock the connectors.
5. Connect battery.