Durango 4WD V8-5.9L VIN Z (1998)
Seat Belt Height Adjuster: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the driver side seat, adjuster and motors assembly from the vehicle as a unit.
3. Unplug the power seat wire harness connectors at each of the three power seat motors.
4. Release the power seat wire harness retainers from the seat adjuster and motors assembly.
5. Remove the four screws that secure the power seat adjuster and motors assembly to the seat cushion frame.
6. If the vehicle is equipped with a split bench seat, remove the fasteners that secure the center seat cushion section to the brackets on the power seat
adjuster.
7. Remove the power seat adjuster and motors assembly from the seat cushion frame.
8. Reverse the removal procedures to install.
