Durango 4WD V8-5.9L VIN Z (1998)
Rear Speed Sensor Mounting
3. Remove mounting stud from the sensor and shield.
4. Remove sensor and shield from differential housing.
5. Disconnect sensor wire harness and remove sensor.
INSTALLATION
1. Connect harness to sensor. Be sure seal is securely in place between sensor and wiring connector.
2. Install O-ring on sensor (if removed).
3. Insert sensor in differential housing.
4. Install sensor shield.
5. Install the sensor mounting stud and tighten to 24 Nm (200 inch lbs.).
6. Install the brake line on the sensor stud and install the nut.
7. Lower vehicle.
