Durango 4WD V8-59L Crankshaft Position Sensor Location: Page 577
Crankshaft Position Sensor: Service and Repair
REMOVAL
Crankshaft Position Sensor
The sensor is bolted to the top of the cylinder block near the rear of right cylinder head. The sensor is accessed by removing the right front fender
liner.
1. Remove right front tire and right front wheelhouse liner.
2. Disconnect crankshaft position sensor pigtail harness from main wiring harness.
3. Remove two sensor (recessed hex head) mounting bolts.
4. Remove sensor from engine.
INSTALLATION
1. Position crankshaft position sensor to engine.
2. Install mounting bolts and tighten to 8 N.m (70 in. lbs.) torque.
3. Connect main harness electrical connector to sensor.
4. Install right front tire and right front wheelhouse liner.
