Durango 4WD V8-5.9L VIN Z (1998)
Key Cylinder - Rear View
1. Rotate flag on rear of ignition switch until in RUN position. This step must be done to allow tang on key cylinder to fit into slots within ignition
switch.
Installing Key Cylinder Into Switch
2. With key into ignition key cylinder, rotate key clockwise until retaining pin can be depressed.
3. Install key cylinder into ignition switch by aligning retaining pin into retaining pin slot. Push key cylinder into switch until retaining pin engages.
After pin engages, rotate key to OFF or LOCK position.
4. Check for proper retention of key cylinder by attempting to pull cylinder from switch.
Ignition Switch View From Column
