Durango 4WD V8-5.9L VIN Z (1998)
Power Window Switch: Service and Repair
REMOVAL
Driver Side Front Door
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from the inside of the driver side front door.
3. From the back side of the trim panel, remove the screws that secure the power window and lock switch unit to the switch bezel in the door trim
panel opening.
4. Remove the power window and lock switch and the switch bezel from the door trim panel.
5. Reverse the removal procedures to install. Tighten the mounting screws to 2.2 N.m (20 in. lbs.).
Passenger Door
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from the inside of the front or rear passenger door.
3. With a small thin-bladed screwdriver, gently pry the snap clips at the sides of the power window switch receptacle on the back of the door trim
panel switch bezel and pull the switch out of the receptacle.
4. Reverse the removal procedures to install. Be certain that both of the switch snap retainers in the receptacle on the back of the door trim panel
switch bezel are fully engaged.
