Durango 4WD V8-5.9L VIN Z (1998)
3.
Tighten the 10 mm generator (black) cable fastener to 90 in-lbs (10 N.m) (Figure 2).
4.
Tighten the 13 mm battery (red) cable fastener to 75 in-lbs (8.5 N.m) (Figure 2).
5.
Install the PDC cover.
6.
Reconnect the battery.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use the following labor operation number and time allowance:
Labor Operation
Time
Number
Allowance
Tighten generator and battery cable
PDC fasteners
08768182
0.2 hours
Note:
See the Warranty Administration Manual, Recall Claim Processing Section for complete recall claim processing instructions.
Parts Return and Vehicle Not Available
Parts Return
Not applicable.
Vehicle Not Available
If a vehicle is not available for service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Notification Form or describe the reason on a postcard and mail to:
Chrysler Corporation
CIMS 482-00-85
800 Chrysler Drive East
Auburn Hills, Michigan 48326-2757
Following the above procedures will expedite the processing of your claim.
If you have any questions or need assistance in completing this action, please contact your Zone Service Office.
Dealer Instructions
IMPORTANT
DEALER SERVICE INSTRUCTIONS
Safety Recall # 768