Durango 4WD V8-5.9L VIN Z (1998)
Ignition Switch Lock Cylinder: Service and Repair
The ignition key must be in the key cylinder for cylinder removal.
Key Cylinder Removal
1. Disconnect negative cable from battery.
2. If equipped with tilt column, remove tilt lever by turning it counterclockwise.
Shroud Removal/Installation - Typical
3. Remove upper and lower covers (shrouds) from steering column.
4. If equipped with automatic transmission, place shifter in PARK position.
Retaining Pin
5. A retaining pin is located at side of key cylinder assembly.
a. Rotate key to RUN position.
b. Press in on retaining pin while pulling key cylinder from ignition switch.
Ignition Switch Removal
1. Remove key lock cylinder. Refer to previous steps.
