Durango 4WD V8-5.9L VIN Z (1998)
Power Steering Fluid Reservoir: Service and Repair
NOTE: Discard all O-ring seals during disassembly, they are not re-usable.
REMOVAL
1. Remove pump assembly.
2. Remove mounting studs and pressure fitting. Rock reservoir by hand or use a soft face mallet and remove reservoir.
3. Remove O-ring seals from housing and discard.
4. Remove flow control valve and spring from housing.
NOTE: Clean all parts before installation. Lubricate new O-ring seals with Mopar (R) Power Steering Fluid or an equivalent product.
INSTALLATION
1. Install flow control valve and spring.
2. Install new O-ring seals on housing and install reservoir.
3. Install mounting studs and tighten to 48 Nm (35 ft. lbs.).
4. Install fitting in flow control valve bore tighten to 75 Nm (55 ft. lbs.).