Durango 4WD V8-5.9L VIN Z (1998)
and the frame crossmember.
9. Remove pitman arm from the gear with Remover C-4150A, or equivalent.
NOTE: Gear mounting bolts must be replaced or use 242 Loctite on existing bolts.
INSTALLATION
1. Align and install the pitman arm on gear and tighten to 231 Nm (185 ft. lbs.).
2. Install steering gear on the frame rail and tighten the bolts to 88 Nm (65 ft. lbs.).
3. Install pitman arm ball stud in center link and tighten nut to 88 Nm (65 ft. lbs.). Install new cotter pin.
4. Remove support and lower vehicle.
5. Install shaft coupler on the steering gear and tighten coupler bolt to 49 Nm (36 ft. lbs.).
6. Connect fluid hoses to steering gear and tighten to 35 Nm (25 ft. lbs.).
7. Fill power steering pump.