Durango 4WD V8-5.9L VIN Z (1998)
7. Remove spool valve O-ring and valve body teflon and O-rings underneath the teflon rings.
8. Remove the O-ring between the worm shaft and the stub shaft.
NOTE: Clean and dry all components, then lubricate with power steering fluid.
ASSEMBLY
1. Install spool valve spool O-ring.
2. Install spool valve in valve body by pushing and rotating. Hole in spool valve for stub shaft pin must be accessible from opposite end of valve
body.
3. Install stub shaft in valve spool and engage locating pin on stub shaft into spool valve hole.
NOTE: Notch in stub shaft cap must fully engage valve body pin and seat against valve body shoulder.
4. Install O-rings and teflon rings over the O-rings on valve body.
