Durango 4WD V8-5.9L VIN Z (1998)
recommended torque only.
LOWER HOUSING
1. Lubricate valves, springs, and the housing valve and plug bores with clean transmission fluid.
2. Install 3-4 timing valve spring and valve in lower housing.
3. Install 3-4 quick fill valve in lower housing.
4. Install 3-4 quick fill valve spring and plug in housing.
5. Install timing valve end plate. Tighten end plate screws to 4 Nm (35 inch lbs.) torque.
3-4 ACCUMULATOR
1. Lubricate accumulator piston, seals and housing piston bore with clean transmission fluid.
2. Install new seal rings on accumulator piston.
3. Install piston and spring in housing.
4. Install end plate on housing.
TRANSFER PLATE
Rear Clutch And Servo Check Ball Locations
1. Install rear clutch and rear servo check balls in transfer plate.
Separator Plate Filter Screen Installation
2. Install filter screen in upper housing separator plate.
